Motor Driver Shield Dual VNH2SP30 30A

604.75

This Motor Driver Shield replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. Its support circuitry is capable of driving a pair of high-current motors! The VIN and motor out are pitched for 5mm screw terminals, making it easy to connect larger gauge wires.

Note: When using this board in extreme high-demand applications it may be necessary to improve thermal performance with a heat-sink or fan and to solder the wires directly to the board instead of using a screw terminal (in addition to the myriad other complications present in a high-current system) However, when using the board at currents up to 6A the chips will barely become noticeably warm.

Category:

Motor Driver Shield Dual VNH2SP30

This Motor Driver Shield replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. Its support circuitry is capable of driving a pair of high-current motors! The VIN and motor out are pitched for 5mm screw terminals, making it easy to connect larger gauge wires.

Note: When using this board in extreme high-demand applications it may be necessary to improve thermal performance with a heat-sink or fan and to solder the wires directly to the board instead of using a screw terminal (in addition to the myriad other complications present in a high-current system) However, when using the board at currents up to 6A the chips will barely become noticeably warm.

Features:

  • Voltage max: 16V
  • Maximum current rating: 30 A
  • Practical Continuous Current: 14 A
  • Current sensing available to Arduino analog pin
  • MOSFET on-resistance: 19 m? (per leg)
  • Maximum PWM frequency: 20 kHz
  • Thermal Shutdown
  • Undervoltage and Overvoltage shutdown

Documents:

Reviews

There are no reviews yet.

Be the first to review “Motor Driver Shield Dual VNH2SP30 30A”

Your email address will not be published. Required fields are marked *